GOT2000 - connection with barcode reader

In the video below you can see how to connect and configure barcode reader to GOT2000

You can find GOT projects in attachment.

• Related Articles

• Connection between GOT 2000 and GT Designer3 (PC) over RCPU with RJ71EN

  This article describes connection between GOT 2000 and GT Designer3 over RCPU with RJ71EN Ten artykuł opisuje połączenie pomiędzy panelem GOT 2000 i oprogramowaniem GT Designer3 poprzez sterownik RCPU z modułem RJ71EN 1. PC -> RCPU -> RJ71EN -> GOT ...

• Sample GOT screens for robot control (FR Series, CR800-D), Full Project

  An official sample GOT2000 project for robot FR Series (CR800-D controller) controlling and monitoring System configuration: Project contains follwing screens: Robot operation Position Edit JOG control HAND control Variable edit Load level monitor ...

• Iconics Suite - GOT project conversion to GraphWorX64 screens

  Summary: this document describes how to convert existing GT designer project to Iconics GraphWorX files Launch GENESIS64 Converter-GOT from Windows Start > ICONICS Tools, specify your GTX project file and fill in a few other settings. The tool will ...

• GOT1000 - Show and hide objects in a GOT HMI project

  Summary:  This document describes how to hide and show objects in GOT1000 depending on bit state. The solution is based on using object scripts  The solution of hiding and showing objects is presented step by step below: Introduction Under certain ...

• Robot error information on GOT

  Document describe how to monitor error code using GOT. 1. Comminication settings Establish standard ethernet communication between robot and GOT. Setup communication driver for robot. We use Extended memmory for data transfer. Refresh time of data is ...