Safety WS RS232 connection cable
This project
contains information about connecting programming cable to Safety WS
Connection
Programming socket (RS232)
Safety WS has got M8 connector for programming
Pin assigment is described on picture below:
Plug/socket |
PIN |
Signal |
|
|
1 |
Reserved |
2 |
RxD |
|
3 |
GND |
|
4 |
TxD |
Orange programming cable (WS0-C20R2)
Diagram of WS0-C20R2:
Related Articles
iQ-F Simple CPU Communication with Siemens S7-1200
This video shows how to communicate Mitsubishi iQ-F controller with Siemens S7-1200 using Simple CPU Communication function. <br> TIA Portal Configuration for PUT/GET Communication To enable proper communication between an S7 PLC and our PLC ...WS0-XTIO-4RO and robot drive unit connection
This document shows wiring example between CR750 robot controller and safety controller WS0-CPU0. The connection is made with use of two extension units connected to the safety controller, input/output unit and safety relay output. Safety Controller ...GENESIS V11 - MQTT connection to iQ-F PLC (FX5-ENET)
This article explains how to read data from an iQ-F series FX5-ENET module to GENESIS V11 using a dedicated decoder. A sample GX Works3 project used in this example is added as an attachment. Precautions The MQTT communication function is officially ...CC-Link IE TSN safety communication with MR-J5G-RJ
This document describes how to start safety communication of CC-Link IE TSN between iQ-R Safety, safety remote I/O and MR-J5G-RJ. "Copyright © Mitsubishi Electric Europe B.V. IMPORTANT ! These Function Blocks are demo versions that are only intended ...Control - Multiple CPU Systems
The following video explains basics of Multiple CPU Systems, the idea behind such setup, CPUs combinations, their configuration, memory structure and parametrization on the GX Works3 side.